Eaton easy800

12 Appendix
12.7 Menu structures
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 367
12.7.2.1 800Unlocking
12.7.3 System menu
▶ The System menu is accessed by simultaneously pressing DEL and ALT.
PASSWORD ENTRY:
------
easy800Unlocking
PASSWORD... Æ
STOP RUN å
PARAMETER
SET CLOCK... æ
Main Menu
PASSWORD...
RUN
DELETE ALL ?
Correct entry
Status display
5 incorrect entries
(if enabled)
OK
Password deleted
OK
DEBOUNCEåÆ
P PUSHBUTTONS
RUN MODE
CARD MODE æ
SECURITY... Æ
SYSTEM...
MENU LANGUAGE
CONFIGURATOR...æ
I-BUTTONS...
R-PUSHBUTTONS...
DISPLAY...
RETENTION...
DEBOUNCE...
P-PUSHBUTTONS...
RUN MODE
CARD START...
Æ
I-BUTTONS...
R-PUSHBUTTONS...
DISPLAY... æ
RETENTION...
DEBOUNCE...
P-PUSHBUTTONS...
RUN MODE
CARD MODE æ
I-
BUTTONS... Æ
R-PUSHBUTTONS...
DISPLAY...
Retention only in STOP mode
￫ section “8.2.1 Switch on input delay”, page 302
￫ section “8.2.2 P PUSHBUTTONS”, page 303
￫ section “ Activating RUN MODE”, page 304
￫ section “8.2.5 Setting contrast and backlight”, page
307
￫ section “8.2.6.1 Setting retentive behaviour”, page 309
System menu
Password setup
SECURITY...
SYSTEM...
MENU LANGUAGE
CONFIGURATOR...
PASSWORD...
RANGE…
PASSWORD ENTRY:
------
CHANGE PW
ACTIVATE PW
PASSWORD...
RANGE…
￫ section “ Protecting special areas”, page 298
PASSWORD ENTRY:
------
CHANGE PW
ACTIVATE PW
Changing the password with the device unlocked
SECURITY...
SYSTEM...
MENU LANGUAGE
CONFIGURATOR...
PASSWORD...
RANGE…
1