Eaton easy800

2 Installation
2.1 Mounting 800
20 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
2.1 Mounting 800
Install a easy800 device in an enclosure, switch cabinet or distribution board
so that the power supply and terminal connections cannot be touched
accidentally during operation.
Snap the device onto an IEC/EN 60715 top-hat rail or fix it in place using
fixing brackets. The easy800 device can be mounted either vertically or
horizontally.
For ease of wiring, leave a gap of at least 3 cm between the device terminals
and the wall or adjacent devices.
￫
When using the easy800 device with expansion units, connect
the expansion unit concerned before mounting
(￫ section 2.2, “Mounting the expansion unit”, page 22).
Figure 3: Vertical mounting easy800
standard and easy800-SWD
Figure 4: Horizontal mounting easy800
standard and easy800-SWD
30 mm
(1.18“)
30 mm
(1.18“)
30 mm
(1.18“)
30 mm
(1.18“)
30 mm
(1.18“)
30 mm
(1.18“)