5 Function blocks
5.28 SC, set date/time
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 241
5.28 SC, set date/time
This function block allows you to selectively place the date and time onto the
network. All other stations accept the date and time of the sending station.
easy800 device allows the use of one “set date/time function block”.
EASY802-DC-SWD is not provided for the function block.
Contacts and Coils
Example of a set date/time function block:
Figure 175:Wiring the trigger coil
The trigger coil is connected to a device input.
Figure 176:Wiring of the function block contact
The contact is assigned to a marker.
Parametric programming of the function block inputs/outputs
This function block is a triggerable system service. It therefore does not have
any parameters.
SC diagnostics
The SC function block only functions if the easyNet network is running
properly (￫ section 9.6, “800 standard expanding”, page 325).
Contacts
Meaning
SC01Q1 The trigger coil is active
Coils
Function
SC01T_ Trigger coil, on rising edge the function block transfers date and time of the sending station to the
NET
To Next Page
Loading...
