Eaton easy800

4 Wiring with 800
4.2 Program
102 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
• Connections are used to produce the electrical contact between relay
contacts and the coils. They can be created across several rungs. Each
point of intersection is a connection.
• The number of free bytes is displayed so that you can recognize how
much memory is available for the circuit diagram and function blocks.
4.2 Program
An easy800 program consists of the necessary settings for the device,
easyNet, password, system settings and operating parameters and the
following components:
• Circuit Diagram
• Function block list
• Function block plan
• Project configuration (applies only to easy800-SWD)
• Assignment list (applies only to easy800-SWD)
• SWD parameters (applies only to easy800-SWD)
￫
The circuit diagram display performs two functions:
• It is used to edit the circuit diagram in STOP mode.
• It is used in RUN mode to check the circuit diagram using
the power flow display.
I 01----I 02----CP01GT---------Ä Q 01
Q 01----HY01Q1kêêêêêêêêêêêêêê êêêêêêêê
êêêêêê 'êêêêêê 'êêêêêêêêêêêêêê êêêêêêêê
L: 1 C:1 B:____
Contact fields (1 to 4) Coil field (5)
Connections
Rungs
Status bar
Number of
rung
Number of the
field in the
rung
Amount of free
memory in bytes