4 Wiring with 800
4.7 Working with function blocks
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 129
4.7.2 Function block list
The function block list is shown on the way to the function block editor.
To access the function block list from the status list, click
▶ OK -> PROGRAM -> PROGRAM -> FUNCTION BLOCKS
This lists all function blocks that were ever used in the circuit diagram, and
also those that were already deleted in the circuit diagram. The function
block list is empty if no function blocks are present.
In our example, the function block list contains the function blocks AR, CP
and T. The function blocks are created in the order in which they were
edited.
Figure 100:Explanation of the function block list
▶ Use the cursor buttons ÍÚ ú í to select the required function block from
the function block list, in this case timing relay T01.
▶ Confirm your selection with OK.
The timing relay is displayed in the function block editor.
4.7.3 Parameter setting in the function block editor
The function block can be fully parameterized in the function block editor.
This is accessed via the function block list. Access is blocked if the program
is password protected.
Figure 101:Display of the function blocks in the function block editor
To Next Page
Loading...
