Eaton easy800

2 Installation
2.6 Connecting outputs
46 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Note that only outputs of the same group can be connected in parallel.
Groups are
• Q1 to Q4
• Q5 to Q8
• S1 to S4
• S5 to S8
Outputs connected in parallel must be switched at the same time.
2.6.1 Connect relay outputs
Connecting relay outputs of the 800 standard
Figure 45:Relay outputs EASY8..-..RC.

DANGER
Only outputs of the same group (S1 to S4 or S5 to S8) can be
connected in parallel; e.g. S1 and S3 or S5, S7 and S8. Outputs
connected in parallel must be switched at the same time.

DANGER
Do not exceed the maximum voltage of 250 V AC on a relay
contact. If the voltage exceeds this threshold, flashover may
occur at the contact, resulting in damage to the device or a
connected load.
+ 24 V H
0 V H, N
F
8 A/B 16
L1, L2, L3 (115/230 V h)
25 000
RL
24 V H 8 A
115 V h 8A
230 V h 8A
2A
2A
2A
1000 W
10 x 58 W
12 2 2 2 2 2
1
1
1
1
1
10 000 000
Q6Q5Q4Q3
Q2
Q1