2 Installation
2.8 Connecting the serial interface
66 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
2.8.4 Inserting the memory card
easy800 standard devices support the use of memory cards that are fitted
into the serial interface. The memory card can be used to store a single
program that can be read from any suitable easy800 standard device.
With easy800 standard only use the EASY-M-256K card.
▶ Remove the cover from the interface and connect the connector memory
card ￫ Figure 64, page 66.
Working with the memory card ￫ section 4.6, “Program transfer from and
to the memory card”, page 124.
Figure 64:Connecting and removing the memory card
￫
With easy800 standard you can also remove or insert the
memory card when the power supply is switched on without
any risk of data loss.
To Next Page
Loading...
