Eaton easy800

2 Installation
2.8 Connecting the serial interface
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 63
2.8.3 Connecting for point-to-point communication
Connect a connection cable from the MFD device to the serial interface of
the easy800 device.
Table 5: Prefabricated connection cables for point-to-point communication
Connecting example 800 standard to MFD-…-CP8/CP10
Figure 61:Fitting/removing the interface cover
▶ Remove the cover from the serial interface and connect the connector
plug of the MFD-800-CAB5.
Device
Connection cable Device Baud Rate
easy800 standard MFD-CP4-800-CAB5 EASY209-SE up to 57.6 KBaud
MFD-CP4 up to 19.2 KBaud
MFD-800-CAB5 MFD-CP8
MFD-CP10
up to 19.2 KBaud
easy800-SWD EU4A-RJ45-CAB2 MFD-CP4 up to 19.2 KBaud
EASY209-SE up to 57.6 KBaud
￫
In order ensure compliance with EMC requirements, the
MFD-800-CAB5 cable must not be lengthened.