Eaton easyE4

3. Commissioning
3.11 Set system parameters using a memory card - e4settings.ini
Timeout Brightness - Timeout for brightness changeover
Indication of time in seconds when the display changes to rest mode
if no operation takes place on the easyE4 device.
The changeover time between this display brightness 1 and 2 must be indicated in
seconds in accordance with the following table.
0 s
10 s
30 s
60 s (1 min)
120 s (2 min)
300 s (5 min)
600 s (10 min)
900 s (15 min)
Tab. 21: Timeout
Brightness
If an intermediate value is indicated in seconds, the value is rounded up to the
nearest second in accordance with the table.
Example: If 2 seconds are indicated in the *.ini file, the value is rounded up to 10
seconds.

easyE402/24 MN050009ENEaton.com
149