Eaton easyE4

10. easyE4 communication Connection to other devices
10.9 Setting up a connection to multiple devices on the NET
Fig. 313: Selection of NET station
Select the NET station. All the NET stations in the project will be available.
The program and all project settings (i.e., the NET ID and Ethernet settings) for the
selected NET station will be loaded onto the easyE4 device.
In the Project view work pane, select the next easyE4 device in the NET group.
Search for the devices in the NET group,
select the next device that should correspond to the next device in the project
from the list of found devices, and
go ONLINE, → Section "Establish a connection to the device", page 685.
In the Connection section, click on the PC => Device button.
Select the NET station.
Repeat these steps for every device that you want to configure in the project.
Project view
Fig. 314: NET configuration with project and program
Connection parameters on device
The computer can use easySoft 8 to establish a connection without a project or pro-
gram and download the parameters for establishing a connection to each easyE4
device.
However, the Enable configuration via network option must be enabled on the
device. This is only possible if the project has been loaded, with the option enabled,
onto the device at least once..
easyE402/24 MN050009ENEaton.com
691