Eaton Network-M2 - Page 107

Settings
Contextual help of the web interface – 107
•
•
•
•
HTTPS Port — 443 Port — x-xxx
Syslog Inactive
Server#1
Name – Primary
Status – Disabled
Hostname – empty
Port – 514
Protocol – UDP
Message transfer method – Non transparent
framing
Using unicode byte order mask (BOM)– disabled
Server#2
Name – empty
Status – Disabled
Hostname – empty
Port – 514
Protocol – UDP
Message transfer method – DIsabled in UDP
Using unicode byte order mask (BOM)– disabled
Inactive/Active
Server#1
Name – 128 characters maximum
Status – Disabled/Enabled
Hostname – 128 characters maximum
Port – x-xxx
Protocol – UDP/TCP
Message transfer method – Non transparent
framing
Using unicode byte order mask (BOM)– disable/
enable
Server#2
Name – 128 characters maximum
Status – Disabled/Enabled
Hostname – 128 characters maximum
Port – x-xxx
Protocol – UDP/TCP
Message transfer method (in TCP)– Octet
counting/Non transparent framing
Using unicode byte order mask (BOM)– disable/
enable
3.7.4.3.1 For other settings
3.7.4.4 Access rights per profiles
Administrator Operator Viewer
Network & Protocols
3.7.4.4.1 For other access rights
For other settings, see the Information>>>Default settings parameters section.
For other access rights, see the Information>>>Access rights per profiles section.