Eaton Network-M3 - Page 116

Settings
Contextual help of the web interface – 116
3.7.5.4.2 DHCP
Select DHCP and Save the configuration.
3.7.5.5 CLI commands
netconf
Description
Tools to display or change the network configuration of the card.
Help
For Viewer and Operator profiles:
netconf -h
Usage: netconf [OPTION]...
Display network information and change configuration.
-h, --help display help page
-l, --lan display Link status and MAC address
-4, --ipv4 display IPv4 Mode, Address, Netmask and Gateway
-6, --ipv6 display IPv6 Mode, Addresses and Gateway
-d, --domain display Domain mode, FQDN, Primary and Secondary DNS
For Administrator profile:
netconf -h
Usage:netconf[OPTION]...
Display network information and change configuration.
-h,--helpdisplayhelppage
-l,--landisplayLinkstatusandMACaddress
-d,--domaindisplayDomainmode,FQDN,PrimaryandSecondaryDNS
-4,--ipv4displayIPv4Mode,Address,NetmaskandGateway
-6,--ipv6displayIPv6Mode,AddressesandGateway
Setcommandsareusedtomodifythesettings.
-s,--set-lan<linkspeed>
Linkspeedvalues:
auto Autonegotiation
10hf 10Mbps-Halfduplex
10ff 10Mbps-Fullduplex
100hf 100Mbps-Halfduplex
100ff 100Mbps-Fullduplex
1000ff1.0Gbps-Fullduplex
-f,--set-domainhostname<hostname>setcustomhostname
-f,--set-domain<mode>
Modevalues:
-setcustomNetworkaddress,NetmaskandGateway:
manual<domainname><primaryDNS><secondaryDNS>
- automaticallysetDomainname,PrimaryandSecondaryDNS
dhcp
-i,--set-ipv4<mode>