Eaton Network-M3 - How do I log in if I forgot my password?

How do I log in if I forgot my password?
Troubleshooting – 290
•
•
8.5.1.3 Action #1-2
1- Check the EMPs connection and cables.
Refer to the sectionsServicing the EMP>>>Installing the EMP>>>Cabling the first EMP to the deviceandServicing the
EMP>>>Installing the EMP>>>Daisy chaining 3 EMPs.
2- Disconnect and reconnect the USB to RS485 cable.
3- Launch the discovery, if it is still not ok, go to Action #1-3.
8.5.1.4 Action #1-3
1- Reboot the Network module.
2- Launch the discovery.
8.5.2 Symptom #2
The EMPs orange RJ45 LEDs are not blinking.
8.5.2.1 Possible causes
C#1: the EMP address switches are all set to 0.
C#2: the EMPs are daisy chained, the Modbus address is the same on the missing EMPs.
8.5.2.2 Action #2-1
1- Change the address of the EMPs to have different address and avoid all switches to 0.
Refer to the sectionServicing the EMP>>>Defining EMPs address and termination>>>Manual addressing.
2- Disconnect and reconnect the USB to RS485 cable. The address change is only taken into account after an EMP power-up.
3- Launch the discovery,if it is still not ok, go to Action #2-2.
8.5.2.3 Action #2-2
1- Reboot the Network module.
Refer to the sectionContextual help>>>Maintenance>>>Services>>>Reboot.
2- Launch the discovery.
8.6 How do I log in if I forgot my password?
8.6.1 Action
Askyour administrator for password initialization.
If you are the mainadministrator, yourpasswordcan be reset manually by following steps described in theServicing the
Network Management Module>>>Recovering main administrator password.