Eaton Network-M3 - Environment

Environment
Contextual help of the web interface – 68
•
•
•
•
•
•
•
•
•
•
•
•
•
Client server is not restarting
Symptom
Utility power has been restored, the UPS and its load segments are powered on, but the Client server does not restart.
Possible Cause
The “Automatic Power ON” server setup setting might be disabled.
Action
In the server system BIOS, change the setting for Automatic Power ON to "Enabled".
3.5.3.4.1 For other issues
3.6 Environment
3.6.1 Commissioning/Status
3.6.1.1 Sensors commissioning/Status table
The table displays the sensors commissioning information and includes the following details.
Name
Location –location-position-elevation
Temperature
Humidity
Dry contact #1 –Status and name
Dry contact #2 –Status and name
Communication –Connected/Lost with dates
3.6.1.2 Actions
3.6.1.2.1 Download sensors measures
Press theDownload sensors measuresbuttonto download the sensors log file:
If available, possible measures are listed below:
Temperature of <sensor_1> (in K, 1 decimal digit)
Humidity of <sensor_1> (in %, 1 decimal digit)
Temperature of <sensor_2>> (in K, 1 decimal digit)
Humidity of <sensor_2>(in %, 1 decimal digit)
Temperature of <sensor_3>(in K, 1 decimal digit)
Humidity of <sensor_3>(in %RH, 1 decimal digit)
For details on other issues, see the Troubleshooting section.
°C = K - 273.15
°F = K x 9/5 -459.67