Eaton Network-M3 - Cabling the First EMP to the Device

Installing the EMP
Servicing the EMP – 223
•
•
•
•
•
6.3.3 Cabling the first EMP to the device
6.3.3.1 Available Devices
Unable to render include or excerpt-include. Could not retrieve page.
Unable to render include or excerpt-include. Could not retrieve page.
6.3.3.2 Connecting the EMP to the device
6.3.3.2.1 Material needed:
EMP
RJ45 female/female connector (supplied in EMP accessories)
USB to RS485 converter cable(supplied in EMP accessories)
Ethernet cable (not supplied).
Device
6.3.3.2.2 Connection steps
STEP 1 – Connect the "USB to RS485 converter cable" to the USB port of the Device.
STEP 2 – Connect the "USB to RS485 converter cable" to the RJ45 female/female connector.
STEP 3 –Connect the Ethernet cableto theother end of the RJ45 female/female connector.
STEP 4–Connect the other end of the Ethernet cable to the RJ-45 port on the EMP (FROM DEVICE).
Address must be defined before the EMP power-up otherwise the changes won't be taken into account.
Do not set Modbus address to 0,otherwise the EMP will not be detected.
Use the supplied tie wraps to secure the "RS485 to USB cable" to the Network cable.