Eaton Network-M3 - Netconf

CLI
Information – 273
7.7.7 netconf
7.7.7.1 Description
Tools to display or change the network configuration of the card.
7.7.7.2 Help
For Viewer and Operator profiles:
netconf -h
Usage: netconf [OPTION]...
Display network information and change configuration.
-h, --help display help page
-l, --lan display Link status and MAC address
-4, --ipv4 display IPv4 Mode, Address, Netmask and Gateway
-6, --ipv6 display IPv6 Mode, Addresses and Gateway
-d, --domain display Domain mode, FQDN, Primary and Secondary DNS
For Administrator profile:
netconf -h
Usage: netconf [OPTION]...
Display network information and change configuration.
 -h, --help display help page
 -l, --lan display Link status and MAC address
 -d, --domain display Domain mode, FQDN, Primary and Secondary DNS
 -4, --ipv4 display IPv4 Mode, Address, Netmask and Gateway
 -6, --ipv6 display IPv6 Mode, Addresses and Gateway
 Set commands are used to modify the settings.
-s, --set-lan <link speed>
 Link speed values:
 auto Auto negotiation
 10hf 10 Mbps - Half duplex
 10ff 10 Mbps - Full duplex
 100hf 100 Mbps - Half duplex
 100ff 100 Mbps - Full duplex
 1000ff 1.0 Gbps - Full duplex
-f, --set-domain hostname <hostname> set custom hostname
-f, --set-domain <mode>
Mode values:
- set custom Network address, Netmask and Gateway:
manual <domain name> <primary DNS> <secondary DNS>
- automatically set Domain name, Primary and Secondary DNS
dhcp
-i, --set-ipv4 <mode>
Mode values:
- set custom Network address, Netmask and Gateway
manual <network> <mask> <gateway>
- automatically set Network address, Netmask and Gateway
dhcp
-x, --set-ipv6 <status>