Eaton Network-M3 - Page 132

Settings
Contextual help of the web interface – 132
a Enable theSNMP agent
In addition to this, v1/V2C and/or v3 must be enabled, along with appropriate communities and activated user accounts to allow
SNMP communication.
PressSaveafter modifications.
b Configure the SNMP V1/V2C settings:
1. Click the edit icon on either Read Only or Read/Write account to access settings:
2. Enter the SNMP Community Read-Only string. The Network Module and the clients must share the same community name to
communicate.
3. SelectActivein the Enabled drop-down list to activate the account.
4. Access level is set to display information only.