Eaton PowerXL DC1 - Adjust Parameters; Resetting Parameters (RESET)

4 Operation
4.5 Handling the keypad
120 DC1 Variable Frequency Drive 04/16 MN04020003Z-EN www.eaton.com
4.5.2 Adjust parameters
Table 15: Modify parameters
4.5.3 Resetting Parameters (RESET)
Table 16: Resetting parameters (RESET)
Commands
Description
Press the OK button and hold it down for two seconds in order to access the parameter interface.
→ The display will show the parameter that was last used.
Use the ▲ and ▼ buttons to select a parameter.
Press the OK button.
The value of the selected parameter can be changed.
Use the ▲ and ▼ buttons to change the parameter’s value.
Press the OK button to confirm the parameter value change.
As soon as the parameter is displayed, the value will have been saved.
Press the OK button and hold it down for two seconds in order to exit the parameter interface (display: Stop).
Commands Description
Reset to default settings
++
Press the ▲ and ▼ and STOP buttons and hold them down for two seconds.
→ All parameters will be restored to their default settings.
The display will show P-dEF.
Resetting after a fault
Press the STOP button to reset a fault message.
The display will show StoP.