Eaton PowerXL DC1 - IP66; NEMA4 X Degree of Protection

3 Installation
3.4 IP66 / NEMA4X degree of protection
DC1 Variable Frequency Drive 04/16 MN04020003Z-EN www.eaton.com 65
3.4 IP66
/ NEMA4X degree of protection
IP66 DC1 variable frequency drives are available in two versions:
• DC1-…-A66N: Activation via control signal terminals
• DC1-…-A6SN: Controlled with controls on the front and/or control signal
terminals
Figure 31: IP66 variants
The units must be mounted, with four screws and in a vertical position, on a
wall or panel that is made of nonflammable material and is stable enough to
hold the variable frequency drive’s weight.
On the DC1-…-A6SN version, the main disconnect switch can be locked in
the OFF position with a standard padlock.
DC1-…-A66N DC1-…-A6SN
Figure 32: Openings for fixing
screws
PWR
OFF
ON
REV
FWD
0
= 4 x M4
1 Nm (8.85 lb-in)
FS1, FS2, FS3
Figure 33: DC1-…-A6SN with
padlock
 Push on the center of
the switch in order to
open the opening for
the padlock.
PWR
OFF
ON
REV FWD
0
ON
OFF
PWR
⌀ = 5 mm ￫ 2 x
( = 0.20" ￫ 2 x)
