Edwards STP-iS2207 Series - Name and Function of the Control Unit

STP-iS2207 Series Turbomolecular Pump
MT-89E-001-C
Page 28
INSTALLATION
3
3.3.2 Name and function of the control unit
Figure 17 shows the front panel of the control unit.
WARNING
A hazardous live voltage may exist at the connectors that are marked with the
warning sign . DO NOT touch the connecter. Doing so may result in electric
shock. When connecting/disconnecting the connecter, always power off the primary
power (switch the MAIN POWER to "OFF") and isolate (Lockout/Tagout) the
electrical energy source, water and gas, and other energy sources on the vacuum
equipment.
CAUTION
The "STP-LINK" connector (X5) is waterproof and dust-proof when the cover is attached. When
the STP-Link and Display unit iDT-001 are connected, the waterproof and dust-proof state of the
pump cannot be maintained. DO NOT leave the STP-Link and Display unit iDT-001 constantly
connected to the pump in an environment affected by dust and water splashes. There is a risk that
the STP pump may fail.