To Next Page

To Previous Page

Warning

1. All work on this product (system design, installation, operation, setting, configuration,

and maintenance) must be carried out by qualified personnel. To reduce the risk of electric shock,

do not perform any servicing other than those specified in the operating instructions unless you

are qualified to do so.

2. Read all instructions before installing. For electrical work, follow all local and national wiring

standards, regulations, and these installation instructions.

3. Make sure the inverter is properly grounded. All wiring should be in accordance with the

National Electrical Code (NEC), ANSI/NFPA 70.

4. The inverter and system can inter-connect with the utility grid only if the utility provider per-

mits. Consult with your local AHJ (Authority Having Jurisdiction) before installing this product

for any additional regulations and requirements for your area.

5. All warning labels and nameplates on this inverter should be clearly visible and must not be

removed or covered.

6. The installer should consider the safety of future users when choosing the inverter’s correct

position and location as specified in this manual.

7. Please keep children away from touching or misusing the inverter and relevant systems.

8. Beware! The inverter and some parts of the system can be hot when in use, please do not touch

the inverter’s surface or most of the parts when they are operating. During operation, only the

LCD and buttons should be touched.

DISCLAIMER

EG4 reserves the right to make changes to the material herein at any time without notice. You may refer

to the EG4 website at www.eg4electronics.com for the most updated version of our manual.

Other manuals for EG4 18KPV

Questions and Answers:

Need help?

Do you have a question about the EG4 18KPV and is the answer not in the manual?

General