eKey Home - Page 49

48│en Usage of the finger scanner with the control panel menu
Using an RFID transponder
NOTICE
Only in the case of an RFID function: You can only open a door using
an RFID transponder for finger scanners with an RFID function.
Step
Action
Description
Display
1st
Hold a stored RFID
transponder up to the
finger swipe area of the
finger scanner.
The status
LED lights
up green.
Short beep.
The status
LED lights
up red.
Long beep.
The RFID transponder
was not recognized.
Repeat step 1 with a
valid RFID transponder.
Alternatively, hold the
RFID transponder closer
to the finger scanner or
for a longer period of
time.
-
-
2nd
No action
required.
The door opens.
The status
LED lights
up blue.
The system is in normal mode.
Using the digital input (request-to-exit button function)
NOTICE
Only for ekey home control panel integra: You can only open a door
using the digital input with the ekey home control panel integra.
You can also open the door using the request-to-exit button function of
the digital input on the ekey home control panel integra. The relay
switches for the defined relay switch duration. If the digital input is
enabled for longer than the defined relay switch duration, the relay
switches for as long as the digital input is enabled.