Usage of the finger scanner with the control panel menu en│35
Usage of the finger scanner with the
control panel menu
The devices must have been commissioned before you start your system
administration.
See Commissioning the system, page 19.
The system is in normal mode. The control panel menu is used for
programming the system.
Entering the security code grants you access to the main menu. The main
menu is used to configure the system. The default security code is 99.
You can also determine whether your finger scanner is a Bluetooth finger
scanner by entering the security code.
ATTENTION
Change the security code immediately: The security code enables
access to the main menu.
If you do not change the security code, it may be possible for
unauthorized persons to get into your main menu and then gain access to
your premises.
Change the default security code immediately after commissioning!
Choose a new security code and keep it secret.
See Changing the security code, page 37.
NOTICE
30-minute system lock if code is entered incorrectly 3 times: The
system will remain locked for 30 minutes if you enter an incorrect security
code 3 times in succession.
To Next Page
Loading...
