eKey Home - Setting the Brightness of the Back-Illumination

Usage of the code pad with shortcuts en│59
The brightness of the back-illumination can be set using 4 predefined
modes. By default, the back-illumination is set to 100%. Enter the
number of the required illumination:
□ 0 = back-illumination off
□ 1 = back-illumination at 33%
□ 2 = back-illumination at 66%
□ 3 = back-illumination at 100%
The back-illumination brightness is set via the Admin menu.
Enter the admin code to access the Admin menu.
See Entering the admin code, page 54.
The system is in the Admin menu.
Step
Action
Description
Display
1st
Press 5, 2, and the
number of the
required mode. E.g., 1
for 33%.
The status LED
lights up green
on the left.
2nd
Press ✓.
The status LEDs
light up green.
The status LEDs
light up red.
Something has been
entered incorrectly.
The brightness was
not changed. Enter the
admin code from the
beginning again.
-
-
3rd
No action
required.
-
The status LEDs
are off.
The back-illumination brightness was set. The system is in normal mode.
Setting the
brightness of
the back-
illumination