eKey Home - Via the Code Pad

Resetting the system to default settings en│71
The process of resetting to the default settings is initiated via the Admin
menu of the code pad.
Enter the admin code to access the Admin menu.
See Entering the admin code, page 54.
The system is in the Admin menu.
Step
Action
Description
Display
1st
Press 4.
The status LED
lights up green
on the left.
2nd
Press ✓.
The status LEDs
light up red.
3rd
Enter the admin code
on the keypad.
-
-
4th
Press ✓.
The status LEDs
are off.
The status LEDs
light up red.
The admin code was
not recognized. The
system was not reset.
Enter the admin code
from the beginning
again.
-
-
5th
No action
required.
-
The status LEDs
flash yellow
alternately.
The system has been reset to its default settings. You can now
recommission the system.
See step 3 of Commissioning the system, page 19.
Via the code
pad