Maintenance en│75
Maintenance
The system is largely maintenance-free.
The sensor surface of the finger scanner is essentially self-cleaning due to
repeated use (swiping of fingers). However, if the finger scanner becomes
soiled, clean it with a damp (not wet), non-abrasive cloth. Q-tips,
microfiber cloths, and glasses-cleaning cloths are suitable for this
purpose. Cotton-containing materials, paper towels, tissues, kitchen
sponges, damp dish towels, and kitchen roll are not suitable. Use clean
water without adding detergent. Treat the sensor surface with care.
For safety, clean fingerprints and dirt off the code pad from time to time
using a damp (not wet), non-abrasive cloth. Use clean water without
adding detergent.
Disposal
Pursuant to Directive 2012/19/EU of the European Parliament and of the
Council of 4 July 2012 on waste electrical and electronic equipment,
electrical and electronic equipment supplied after August 13, 2005 is to be
recycled. It must not be disposed of with household waste. As disposal
regulations within the EU can differ from country to country, please
contact your dealer for further information as necessary.
To Next Page
Loading...
