eKey Home - Page 64

Usage of the code pad with shortcuts en│63
Step
Action
Description
Display
6th
Press OK.
The status
LEDs light up
green.
7th
Enter the required
user code on the
keypad.
-
-
8th
Press ✓.
The status LED
lights up green
on the right.
The status
LEDs light up
red.
The user code is
already present. Start
again at step 1.
-
-
9th
Enter the required
user code again on the
keypad.
-
-
10th
Press ✓.
The status
LEDs light up
green.
The status
LEDs light up
red.
The two entries do not
match. The user code
was not stored. Start
again at step 1.
-
-
11th
No action
required.
-
The status
LEDs are off.
The user code is stored. The system is in normal mode.
NOTICE
Testing the user code: Test the newly stored user code on the code pad
immediately.