This document provides information proprietary to Electroline Equipment Inc. and cannot be used or disclosed
without Electroline’s written authorization.
Electroline Equipment Inc. reserves the right to make changes without notice in its products or components as
research and development or marketing conditions warrant. Changes affecting the operation of any component in this
manual will be reflected in a subsequent revision. Electroline Equipment Inc. assumes no responsibility for any
omissions or errors that may appear in this document or for any damages that may result from the use of information
contained herein.
The following are trademarks of Electroline Equipment Inc.: Electroline, EAS Control Unit IV, CLEARPath, TPS,
TPS Control Software.
Other registered trademarks used in this manual (HyperTerminal, Windows 95, Procomm, Workabout, etc.) are the
exclusive property of their owner.
Electroline Equipment Inc.
Research and Development – Technical Publications
8265 St-Michel Boulevard
Montréal, Québec
CANADA H1Z 3E4
T
echnical support
If you have questions or require technical information, please contact Electroline Equipment Inc.’s
technical support department by telephone, fax or electronic mail.
Telephone: (514) 374-6335 (in the Montréal area)
Toll free: 1-800-461-3344 (elsewhere in Canada and the U.S.)
Fax: (514) 374-2257
E-mail address: support@electroline.com
Products and services
To find out more about our products, visit our Web site at www.electroline.com or write to us at
info@electroline.com.
Warranty and repairs
For warranty, repair or return information, please visit our Web site at www.electroline.com.
Control Unit IV Reference Manual
Publication No.: 529-0004 Ver.3
First edition: December 1998
Second edition (revised): December 2000
Third edition (revised): December 2001
All rights reserved
Copyright © 1998, 2000, 2002 Electroline Equipment Inc.
Montréal, Canada
To Next Page
Loading...