Electrolux EWX11831 - Additional Features: Extra Rinse, Door Lock, Buzzer

Technical Support - MDM 16/104 599 77 39-16 Rev. 00
 Extra Rinse:
When the related LED (L29) is lit up, this indicates that the option is enabled (it lights up during
the washing and rinse cycles, and it remains switched off during the drain and spin cycle).
The option remains enabled even after the appliance has been turned off (for subsequent
programmes).
Use the combination of two sensors illustrated in the figure below to enable/disable this option.
 Door lock:
When the related LED (L30) is lit up, the safety device prevents the door opening and
switches off when the door can be opened.
Flashes when the device is about to unlock the door (with door interlock with PTC,
which needs one/two minutes to open).
3.3.2.4 Buzzer
This comprises a multi-tone buzzer and sounds in the following cases:
 When the machine is turned on and off it emits two different tunes.
 When a sensor is pressed it emits a short “Click”
 When the cycle ends this is indicated by a special sequence of “three long beeps” repeated at intervals of
15” for a total of 2 minutes. The sequence can only be stopped by opening the door in appliances where the
instant door safety device with micro-switch is fitted.
 In the event of a malfunction in the machine this is indicated by a special sequence of “three short beeps”
repeated 3 times at intervals of 15” for a total of 5 minutes.
All appliances are fitted with the buzzer, and leave the factory with the option enabled. To disable it use the
combination of sensors.
The volume level is set in the factory and cannot be adjusted by the user.
When the buzzer is disabled (using the combination of sensors) it only emits the short “Click” and the sequence
of “three short beeps” when an alarm is triggered.
During the programme selection phase, the buzzer can be enabled/disabled with a sensor combination (which
may be silk-screen printed on the control panel or described in the instruction manual), but the alarm signalling
remains enabled.
To enable it, touch the sensors simultaneously for 3 seconds. A short beep will confirm that it has been
enabled, whereas two short beeps will confirm that it has been disabled.
P6 P3.0
P6 P3.0