Electrolux EWX11831 - Belt, Pulley, Motor, and Heating Replacement

Technical Support - MDM 85/104 599 77 39-16 Rev. 00
14.6.2 Plastic pulley ( 273 mm)
Remove the back panel (see relevant chapter).
Remove the belt (see relevant chapter).
Insert a retainer to secure the pulley in place.
Unfasten the screw securing the pulley to the drum shaft.
When reassembling, tighten the screw at a torque of 60 Nm.
14.6.3 Motor
Remove the back panel (see relevant chapter).
Remove the belt (see relevant chapter).
Disconnect the power supply connector (1) and the earth faston
(beware as it is fitted with an anti-sliding stop).
Loosen the two front fastening screws (2) as there are no rear ones.
When reassembling:
Restore the connections.
If the clamp securing the wiring to the motor breaks, replace it with
a new one.
When reassembling, tighten the screws at a torque of 11.5 Nm.
14.6.4 Heating
Remove the back panel (see relevant chapter).
Disconnect the connectors of the heating element (1) and NTC probe (2).
Loosen the nut (3) and pull it out.
When reassembling, tighten the nut at a torque of 4 Nm.
1
2
2
1
1
2
3