Technical Support - MDM
21/104
599 77 39-16 Rev. 00
4.3.2.3 Display
Padlock
(See page 15.)
Extra Rinse
(See page 16.)
The following information also appears on the display:
Washing programme time
This appears after a washing programme has been selected. This time
corresponds to the time required for the maximum wash load for each type
of programme.
After the programme has started, the time decreases (and is updated)
minute by minute.
When the time is less than an hour, the initial zeros are not displayed.
End of cycle
End of the programme is indicated by a permanently lit zero
(when the door can be opened).
Selection incorrect
Displays the flashing message “Err”, for one second.
Appears on selecting option that is incompatible with the programme selected,
or when the selector is turned while a cycle is running.
Alarm code
Indicates an anomaly during operation of the machine. Simultaneously to the
displaying of the code on the LCD display, the LED above the START/PAUSE
sensor flashes.
Calculate amount of washing
Only for appliances with PROPORTIONAL programmes
After starting the washing programme the dot starts to flash. At this point the
washing machine calculates the amount of washing inside the drum. When this
phase ends the dot lights up fixed and the three digits display the programme time.
4.3.2.4 Buzzer
(See page 16.)
To Next Page
Loading...
