Technical Support - MDM
27/104
599 77 39-16 Rev. 00
7.1.2 Styling P3.0
When a problem arises with the appliance, “WARNING” appears on the LCD screen, represented by a code
(three digits, indicating the time required for the cycle to end). At the same time the buzzer gives off three short
“beeps” every 20” for a period of 5 minutes.
Once the fault has been repaired the buzzer does not give off any “beeps” and the selected programme
appears on the LCD screen.
Alarms E9x and EHx show the entire code with the red LED + yellow LED, only alarm EHx is not accompanied
by the buzzer sounding.
The alarms displayed to the user are listed below and can also be eliminated by the user:
E10 – Water fill difficulty (tap closed)
E20 – Drain difficulty (filter dirty)
E40 – Door open
EF0 – Excessive detergent (if displayed)
E91 – No communication between the display board and the main board. Switch ON/OFF
E92/E93/E94
.
EF0 – Water leakage (Aqua Control System)
It is displayed to the user, but technical assistance is required to resolve it.
EH0 – Voltage or frequency outside the normal values
It is necessary to wait for power supply voltage and/or frequency to restore nominal conditions.
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage/frequency, which are also displayed
during the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on the
condition that:
The water in the tub is below a certain level.
The water temperature is lower than 55 °C.
The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety reasons:
Cooling water fill if the temperature is higher than 65 °C
Drain until the analogue pressure switch is on empty, during a max. 3-minute interval.
To Next Page
Loading...
