Technical Support - MDM
79/104
599 77 39-16 Rev. 00
14.3.3 Blade
The blade is secured to the drum with slides and secured with blades
carved into the drum.
The blades are secured in place by six slides (as can be seen in the picture)
which fit into purpose-provided runners in the drum strip.
To release the blade from the drum:
Insert a flat-tip screwdriver into the hole (as shown in the figure).
The hole is the first in the second series towards the rear of the blade.
With the screwdriver tilted towards the left.
Push the right-hand tab down.
With the screwdriver tilted towards the right.
Push the left-hand tab downwards.
To Next Page
Loading...
