Technical Support - MDM
33/104
599 77 39-16 Rev. 00
9.2
Description of options
Rinse hold
During the cycle the intermediate rinses and spins are performed.
Stops the appliance with water in the tub before the final spin cycle.
Once the Rinse Hold has ended, the appliance rotates the drum every two minutes for up to a maximum
of 18 hours, after which it stops.
To drain the water, simply press the START/PAUSE button to run the drain and spin cycles.
Pre-wash
Adds a pre-wash phase at the start of the cycle with water heating to 30 °C (or cold, if selected).
In COTTONS and SYNTHETICS cycles, performs a short spin before passing on to the washing phase.
This option cannot be selected for WOOL and HAND WASH cycles.
EXTRA-rinse
Add two rinses to the cycles where featured.
Eliminates the spin at the end of washing.
No spin
It eliminates all the spin phases.
It adds three rinses to the COTTON cycle and one to the SYNTHETIC FABRICS cycle.
Stains
Adds a 5-minute motor movement phase after heating to 40 °C.
Water flow to the pre-wash/stains compartment to introduce the special stain-removal product.
This option cannot be selected for WOOL and HAND WASH cycles.
No spin
It eliminates all the spin phases.
It adds three rinses to the COTTON CYCLE and one to the SYNTHETIC FABRICS cycle.
Daily
Modifies the structure of the COTTONS – SYNTHETICS – DELICATES cycles to obtain good washing
performance in a short space of time.
Super quick
Modifies the structure of the wash phase of the COTTONS – SYNTHETICS – DELICATES cycles by half a load.
Delayed start time
Adds a pause before the start of the programme:
Styling P6 the delay time is displayed by the corresponding LEDs see page 15.
Styling P3.0 see description on page 20 “Finish In”.
To start the cycle immediately after the countdown to the delayed start has already begun:
press the Start/Pause button, cancel the delay time by pressing the relevant button, then press Start/Pause again.
Easy-iron
In COTTON programmes:
Adds three rinse cycles
Eliminates intermediate spin cycles
Performs a pulse spin phase before the final spin
Adds an “untangling” phase after the spin cycle
In SYNTHETIC FABRICS programmes:
Reduces the heating temperature in 50/60 °C cycles to 40 °C
Increases the wash time
Prolongs the cooling phase at the end of the wash phase
Adds one rinse cycle
Adds an “untangling” phase after the pulse spin cycle
To Next Page
Loading...
