E00
No alarm
E11
Water fill difficulty during washing
Tap closed or water pressure too low; Drain pipe improperly positioned;
Water fill solenoid valve faulty; Leaks from water circuit on pressure
switch; Pressure switch faulty; Wiring faulty; Main PCB faulty.
Cycle is paused with door locked START/RESET
E13
Water leaks
Drain pipe improperly positioned; water pressure too low;
Water fill solenoid valve faulty; Water circuit on pressure
switch is leaking/clogged; Pressure switch faulty.
Cycle is paused with door locked START/RESET
E21
Drain difficulty during washing
Drain pipe kinked/clogged/improperly positioned; Drain filter
clogged/dirty; Wiring faulty; Pressure switch faulty; Drain pump
rotor blocked; Drain pump faulty; Main PCB faulty.
Cycle is paused
(after 2 attempts)
START
ON/OFF
RESET
E23
Faulty TRIAC for drain pump Wiring faulty; Drain pump faulty; Main PCB faulty.
Safety drain cycle - Cycle stops
with door open
RESET
E24
Drain pump TRIAC “sensing” circuit
faulty
Main circuit board faulty.
Safety drain cycle - Cycle stops
with door unlocked
RESET
E25
Aqua Control “sensing” circuit faulty Main circuit board faulty.
Safety drain cycle - Cycle stops
with door unlocked
RESET
E31
Electronic pressure switch circuit
faulty
Wiring; Electronic pressure switch; Main PCB. Cycle stops with door locked RESET
E32
Calibration error of the electronic
pressure switch
Drain tube kinked/clogged/improperly positioned; Faulty solenoid;
Drain filter clogged/dirty; Drain pump faulty; Leaks in the pressure
switch hydraulic circuit; Pressure switch faulty; Wiring; Main PCB.
Cycle is paused START/RESET
E35
Overflow
Water fill solenoid valve faulty; Leaks from water circuit on pressure
switch; Wiring faulty; Pressure switch faulty; Main PCB faulty.
Cycle interrupted. Safety drain cycle.
Drain pump continues to operate
(5 min. on, then 5 min. off. etc.)
RESET
E38
Internal pressure chamber is clogged
(water level does not change for at
least 30 sec. of drum rotation)
Motor belt broken; Water circuit on pressure switch clogged. Heating phase is skipped RESET
E41
Door open
Check whether the door is closed properly; Wiring faulty;
Door safety interlock faulty; Main circuit board faulty.
Cycle is paused START/RESET
E42
Problems with door lock
Wiring faulty; door safety interlock faulty; Electrical current leak
between heating element and ground; Main PCB faulty.
Cycle is paused START/RESET
E43
Faulty TRIAC supplying power to
door delay system
Wiring faulty; door safety interlock faulty; Main circuit board faulty.
(Safety drain cycle)
Cycle blocked
RESET
E44
Faulty sensing by door delay system Main circuit board faulty.
(Safety drain cycle)
Cycle blocked
RESET
E45
Faulty sensing by door delay system
TRIAC
Main circuit board faulty.
(Safety drain cycle)
Cycle blocked
RESET
E51
Motor power TRIAC short-circuited Current leakage from motor or from wiring; Main PCB faulty.
Cycle stops with door open
(after 5 attempts)
ON/OFF
To Next Page
Loading...
