Technical Support - MDM
23/104
599 77 39-16 Rev. 00
6 DIAGNOSTICS SYSTEM
6.1
Accessing the diagnostics for P6 and P3.0 stylings
The operations listed below must be carried out within 7 seconds.
STEPS P6 P3.0
1
Switch on the appliance using the ON/OFF button an wait for the main programme
LED to light up.
2
Simultaneously press the START/PAUSE button and the nearest option sensor
(as shown in the diagram).
Keep your fingers on the sensors (for approximately 3 seconds) until the LEDs
begin to flash in sequence (P3.0, also the symbols inside the display).
6.2
Quitting the diagnostics system
In order to exit the diagnostic system turn the appliance off and on again using the ON/OFF button.
If “ELE” appears on the display (P3.0) when you turn the appliance on, repeat the operation of switching
it on and off.
To Next Page
Loading...
