E-TRA3000 F-S-D-V-C_E-Manual 153/162
15 Index
A
Air discharge 74
Attention refer to manual 32, 34, 36, 45, 51
Attention refer to manual (45) 47
B
Bad parameter for this extension 105
Basis fault 105
Burst duration Ramp 83
C
Calibration at EMC PARTNER 101
Capacitor voltage to low 105
CE mark 46
Check before operation 51
Climatic Condition 31
Command BOF 125
Command BTR 125
Command DEF 124
Command E 129
Command EUT 125
Command FID 128
Command GTL 129
Command ID 128
Command IMAX 125
Command IMIN 125
Command IPK 128
Command IT 126
Command LC 128
Command LN 127
Command LS 127
Command LV 127
Command NBR 123
Command PAU 126
Command POL 123
Command PON 124
Command REN 129
Command REP 123
Command ST 127
Command STOP 126
Command STRT 126
Command SYA 124
Command SYF 124
Command TRIG 124
Command TST 123
Command VMAX 125
Command VMIN 125
Command VNOM 123
Command VPK 128
Commands Format 121
Common Mode Disturbance
source 12
Common Mode Test
Technical data 26
Communication error 105
Contact Discharge 74
Control
Indication and LED colours 41
Technical Data 28
control keys
Operation panel 44
Control panel
Control part 41
Control Panel
Front of the TRA3000 F-S-D-V-C 41
Coupling network 149
Coupling path 72
Coupling-Decoupling Network 39
CWG 149
D
dc power on EUT 54
Decoupling network 149
delivered standard set-ups 63
DIP End 79
DIP Level Ramp 86
DIPS
Begin Ramp 87
Definition 78
End Ramp 87
Hints to test set-up 60
Ramps Short Dip 86
Run Mode 93
Run Mode "Long Dip" 93
source 11
Technical data 23
DIPS fault 105
Display (1) 42
Display messages 103
down (15) 43
E
Earth connection (34) 45
Editing EFT test set-ups 71, 74, 75, 78
Editing of SURGE parameters 75
Editing short DIPS 78
EFT
characteristics 11
Coupling path 72
coupling-decoupling network CDN 21
Hints to the test set-up 57
Quick verification by the user 100
Ramps 82
source 9
Synchro angle ramp 83
Technical data 21
EFT fault 105
EFT Run Mode 90
Electromagnetic Compatibility 32
EMC 149
Emergency Stop 45, 49, 90
ENTER (14) 43
Error caused by incorrect inputs 103
Error on PWR1 105
Error on PWR2 105
ESD