EMC-PARTNER TRA3000 S - Rear Panel Overview and Interfaces; 4.2 Rear Panel Overview; Power Supply Details

TRANSIENT3000
46/162
4.2 Rear Panel of the TRA3000 F-S-D-V-C
Fig. 4.2
4.2.1.1 Warnings (40)
High leakage currents. To avoid electric shock the power cord protective grounding conductor must be
connected to ground.
For continued fire protection, replace fuse only with fuse of the specified type and rating. Refer servicing to
qualified personnel. Disconnect power cord before replacing fuse.
Dangerous high-voltage inside. If there is any need to open the instrument, disconnect power cord and wait
at least one minute for full capacitor discharge before opening.
This instrument may be protected by one or more patents or patent applications. Information available upon
request.
4.2.1.2 Power supply of the TRA3000 F-S-D-V-C (41)
The TRA3000 F-S-D-V-C receives its power via power connection (41). A power switch, a fuse and a filter
are built in directly at the mains plug.
Power consumption: turned on minimum < 75VA; maximum power consumption < 150 W, standby < 1 W
The fuse is rated with T 4A / 250 V.
4.2.1.3 Type plate (42)
All important supply information is written on the type plate. Please quote the serial number and type of the
equipment when requesting service or repair.
Typeplate
4.2.1.4 CE mark ( 43)
The CE -mark is needed for the free movement of the goods into and within the European community.
44
45
46
45 48
40
41
42
43
53 55
54
49
50
51
57
56
58
59
60