EMC-PARTNER TRA3000 S - Remote Control Command Set

EMC PARTNER AG
129/162
12.3 Remote Control Command set
Command
TST (TeST)
Explanation: set or query the test mode.
Arguments: characters IMP1, IMP2, IMP3..........., IMP11
Example: TST IMP1
This command must be used at a generator with different wave shapes.
Command VNOM (Voltage NOMinal)
Set or query V-peak [in V]
Argument: Integer
0..Vmax resp. 0..110 of DIP
Example: VNOM 1500
VNOM?
Answer: 1500
Command POL (POLarity)
Explanation: Set or query the Polarity.
Argument: Characters POS, NEG
Example: VNOM 1500
POL NEG
Command REP (REPetition)
Explanation: depends on the type of test:
Argument: Integer
Example: VNOM 1500
POL NEG
REP 10
Command NBR (NumBeR)
Explanation: depends on the type of test:
Argument: Integer 0..30000
Example: NBR 10