Emerson DL8000 - Page 281

DL8000 Preset Instruction Manual
Revised February-2016 DL8000 Keypad Display E-63

14/03/12 12:26:02
Select Component
ENTER to Continue
Exit to Go Back
(SELECT)
Component 1
Press SELECT to choose a component and then press ENTER to move
to the next screen in the process. (Press EXIT to redisplay the Delivery
Type selection screen.)
Select
Meter
After selecting a component, you then select the meter for the
component. The available meters are defined in the Number of Meters
parameter [63,0,20].

14/03/12 12:26:02
Component
Select Meter
ENTER to Continue
EXIT to Go Back
(SELECT)
Component 1
Meter 1
Press SELECT to choose a meter for the displayed component and then
press ENTER to move to the next screen in the process. (Press EXIT to
redisplay the Component selection screen.)
Display
MF/K-factor
After you select a meter and press ENTER, the system displays the
meter factor/K-factor option for the selected meter.
 14/03/12 12:26:02
Component
Meter
MF/K-Factor Option
ENTER to Continue
EXIT to Go Back)
Component 1
Meter 1
Single MF
 14/03/12 12:26:02
Component
Meter
MF/K-Factor Option
ENTER to Continue
EXIT to Go Back)
Component 1
Meter 1
MF Curve
Note: The meter factor/K-factor option shown on this screen is display
only; you cannot change the option using this screen. To change
the option, you must exit product calibration and select a new