Emerson DL8000 - Page 282

DL8000 Preset Instruction Manual
E-64 DL8000 Keypad Display Revised February-2016
component-related option using either the Setup/Configuration
option on the keypad display or ROCLINK 800.
If you are satisfied with the displayed meter factor/K-factor option,
press ENTER to continue. The system then displays the current value
for the meter factor:
 14/03/12 12:26:02
Component
Meter
MF/K-Factor Option
Current MF
EXIT to Go Back
ENTER to Continue
(0-9, .)
Component 1
Meter 1
Single MF
0.999063
Note: This screen does not display if the MF/K-factor Option is MF
Curve.
To continue the process, press ENTER. The system prompts you to
define a maximum number of flow rate set points. (Press EXIT to
redisplay the Component selection screen.)
Select Max
Flow Rate Setpoint
(Single Meter)
After you accept the current meter factor, you define the maximum
number of flow rate set points using the following screen:
 14/03/12 12:26:02
Component
Meter
Sel MAX FR Setpoint
EXIT to Go Back
ENTER to Continue
(SELECT)
Component 1
Meter 1
Flowrate 1
Press SELECT to define the number of flow rate set points. This
applies to all components in the system. You must select at least 1 set
point to a maximum 12 set points. The system updates the No of Points
of Meter Factor Linearization parameter [63,0,109] according to your
choice. For example, if you select Flowrate 4, the system sets parameter
63,0,109 to 4 and the highest flow rate set point is now 4.
To continue the process, press ENTER. The system prompts you to
define the values for each set point. (Press EXIT to redisplay the Max
FR Set points screen.)
Select Flow Point Values
(Single MF)
After you define the maximum number of set points, you then need to
enter flow rates for each set point using the following screen:
Note: This sequence shows the screens for a single meter factor.