EasyManuals Logo

Emerson DSM314 User Manual

Emerson DSM314
519 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #230 background imageLoading...
Page #230 background image
User Manual Chapter 7
GFK-1742F Jan 2020
Programmed Motion 219
(M213) Signed integer constants must be in range of -2147483648 to 2147483647
Motion program contains a signed integer value that cannot be represented in 32 bits.
(M214) SYNC Statement is only valid in multi-axis programs and subroutines
A single-axis motion program or subroutine attempted to define a sync block.
(M215) Multi-axis programs do not support Axis 3 or 4
Commands in multi-axis programs can only reference axis 1 or 2.
(M220) Specified axis is out of range
A single-axis motion program can only reference axis 1, 2, 3, or 4.
(M221) Acceleration must be in range 1 1073741823
An ACCEL command has specified an acceleration outside the valid range.
(M222) Velocity must be in range 1 8388607
A VELOC command has specified a velocity outside the valid range.
(M223) Position must be in range -536870912 536870911
A CMOVE or PMOVE command has specified a position outside the valid range.
(M224) Dwell must be in range 0 60000
A DWELL command has specified a dwell outside the valid range.
(M225) Block number must be in range 1 65535
A motion program or subroutine has attempted to define a block number outside the valid
range.
(M230) Must specify an axis in a multi axis program
ACCEL, VELOC, CMOVE, PMOVE, DWELL, and WAIT commands in a multi-axis program or
subroutine must specify an axis.
(M231) Cannot specify axis in a single-axis program
ACCEL, VELOC, CMOVE, PMOVE, DWELL, and WAIT commands in a single-axis program or
subroutine must not specify an axis.
(M233) Acceleration reassignment without intervening move command
It is illegal to change the acceleration for a given axis if there is not an intervening PMOVE or
CMOVE command.
(M234) Velocity reassignment without intervening move command
It is illegal to change the velocity for a given axis if there is not an intervening PMOVE or
CMOVE command.
(M235) Block number already defined in this program unit
The motion program or subroutine has attempted to define a block number that has already
been defined.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Emerson DSM314 and is the answer not in the manual?

Emerson DSM314 Specifications

General IconGeneral
BrandEmerson
ModelDSM314
CategoryController
LanguageEnglish

Related product manuals