Emerson DSM314 - Page 350

User Manual Chapter 15
GFK-1742F Jan 2020
Using the Electronic CAM Feature 339
Table 75: CAM Example Data Scaled in Inches
Master Position (Inches)
Slave Position (Inches)
0
0
0.075
0.075
0.5
0.25
1
0.5
The table above is shown in inches. In this example, the CAM is programmed in 1000
th
of an
inch. Therefore, convert the values and enter the data into the CAM Editor as shown in Table
76.
Table 76: CAM Example Data Scaled in .001 Inches
Master Position (1000
th
of In)
Slave Position (1000
th
of In)
0 in =0 thousandth of in
0 in = 0 thousandth of in
.075 in = 75 thousandth of in
.075 in = 75 thousand of in
.5 in = 500 thousandth of in
.25 in = 250 thousandth of in
1 in = 1000 thousandth of in
.5 in = 500 thousandth of in
When you enter the data into the CAM editor (Figure 156), some values are automatically
changed by the CAM editor.
Figure 156: CAM Data Table User Units Example