User Manual Appendix H
GFK-1742F Jan 2020
Using VersaPro with the DSM314 501
Figure 264: Hardware Configuration DSM314 Settings Tab
You also need to indicate to Axis #1 that it will use the Axis #2 commanded position as its
CAM Master source. To do this select, the Axis #1 tab in hardware configuration. Go to the
CAM Master Source data entry field. From the drop-down box, select Cmd Position 2. This
will configure Axis #1 to use the Axis #2 commanded position as it’s CAM master source
(Figure 265). While in this tab, change the Home Mode: to Move + and OverTravel Switch to
Disabled.
To Next Page
Loading...
