User Manual Chapter 3
GFK-1742F Jan 2020
Installing and Wiring the DSM314 63
Figure 39: Auxiliary Terminal Board Assembly Side View
The following procedure should be used if you wish to mount the auxiliary terminal board
directly to a panel instead of on a DIN-rail. Remember to save all removed parts for possible
later conversion back to DIN-rail mounting.
1.
Using a small bladed Phillips screwdriver, carefully remove the two screws holding
one UM-45 SEFE side element with foot to the UM 45 profile PCB carrier. Save this
part for possible future use in converting the terminal board back to its DIN-rail
mounting configuration.
2.
Attach one UMK 45-SES side element to the PCB carrier in place of the side removed
in step 1 above, again using the two screws. Be careful to not over tighten the
screws.
3.
Insert one UMK-BF mounting ear into the appropriate two holes in the side element.
Note that the mounting ear has a recessed hole for later inserting a (user supplied)
mounting screw. The recessed hole should face upwards to accommodate the
mounting screw.
4.
Repeat steps 1-3 above for the other side of the terminal board.
To Next Page
Loading...
