Proline Promag 53 MODBUS RS485 Commissioning
Endress+Hauser 83
Performing the "Pulsating flow" Quick Setup
This Quick Setup menu guides you systematically through the setup procedure for all the device
functions that have to be parameterized and configured for measuring pulsating flows. Note that this
has no effect on values configured beforehand, such as measuring range, current range or full scale
value.
a0004431-en
Fig. 56: Quick Setup for measuring severely pulsating flows. Recommended settings see next page.
+
+
E
+
E
3002 3002
3002
4200
4225
8005
6400
6402
6403
6404
4206
4208
4004
4005
B
2002
1003
Esc
E
+
-
XXX.XXX.XX
Yes
Yes
No
No
Configure another totalizer ?
Current output n Freq.-/Pulse output n
Select output type
Quit
Totalizer 2Totalizer 1
Totalizer 3
Selection totalizer
Quit
Totalizer
mode (DAA)
Totalizer
mode (DAB)
Totalizer
mode (DAC)
Frequency Pulse
Operation mode
Measuring mode
Alarm delay
Assign
LF-Cut off
On-value
LF-Cut off
Off-value
LF-Cut off
Pressure
shock suppression
Quit
Quick Setup
Measuring mode
Time constant
Measuring mode
Time constant
Quick Setup
HOME-POSITION
Display
damping
QS
Plusating Flow
Configure another output ?
m
n
o
p
m Only totalizers not yet configured in the current Setup are offered for selection in each cycle.
n The "YES" option remains visible until all the totalizers have been configured. "NO" is the only option displayed
when no further totalizers are available.
o Only the output not yet configured in the current Setup is offered for selection in the second cycle.
p The "YES" option remains visible until both outputs have been parameterized. "NO" is the only option displayed
when no further outputs are available.
To Next Page
Loading...
Need help?
General
