Proline Prowirl F 200 PROFIBUS PA Operation
Endress+Hauser 127
11 Operation
11.1 Reading the device locking status
Device active write protection: Locking status parameter
Navigation
"Operation" menu → Locking status
Function scope of the "Locking status" parameter
Options Description
None The access status displayed in "Access status display" parameter applies → 58.
Only appears on local display.
Hardware locked The DIP switch for hardware locking is activated on the main electronics module.
This prevents write access to the parameters .
Temporarily locked Write access to the parameters is temporarily lock due to device-internal
processing (e.g. data upload/download, reset). Once the internal processing has
been completed, the parameters can be changed once again.
11.2 Adjusting the operating language
Information → 72
For information on the operating languages supported by the measuring device
→ 209
11.3 Configuring the display
• Basic settings for the local display → 82
• Advanced settings for the local display → 118
11.4 Reading measured values
With the Measured values submenu, it is possible to read all the measured values.
11.4.1 Process variables
The Process variables submenu contains all the parameters needed to display the current
measured values for every process variable.
Navigation
"Diagnostics" menu → Measured values → Process variables
‣
Process variables
Volume flow
Corrected volume flow
Mass flow
To Next Page
Loading...
