Endress+Hauser Proline 200 - Switch

Proline Prowirl F 200 PROFIBUS PA Commissioning
Endress+Hauser 125
Parameters which can always be modified via the local display
Certain parameters that do not affect the measurement are excepted from write protection
via the local display. Despite the defined access code, these parameters can always be
modified even if the other parameters are locked.
Parameters for configuring
the local display
Parameters for configuring
the totalizer
↓ ↓
Language Format display Control Totalizer
Contrast display Preset value
Display interval
10.9.2 Write protection via write protection switch
Unlike write protection via a user-specific access code, this allows write access to the entire
operating menu - other than the "Contrast display" parameter - to be locked.
The parameter values are now read only and cannot be edited any more (exception
"Contrast display" parameter):
• Via local display
• Via PROFIBUS PA protocol
+
E
–
3 mm
XXXXXXXXXXXXX
WPCDI
ON
OFF
A0025794
1. Loosen the securing clamp.
2. Unscrew the electronics compartment cover.