Proline Prowirl F 200 PROFIBUS PA Operation
Endress+Hauser 131
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Totalizer status 1 to 3 – Displays the current totalizer
status.
• Good
• Uncertain
• Bad
–
Totalizer status (Hex) 1 to 3 In Target mode parameter,
the Auto option is selected.
Displays the current status
value (hex) of the totalizer.
0 to 0xFF –
* Visibility depends on order options or device settings
11.4.3 Output values
The Output values submenu contains all the parameters needed to display the current
measured values for every output.
Navigation
"Diagnostics" menu → Measured values → Output values
‣
Output values
Terminal voltage 1
Pulse output
Output frequency
Switch status
Parameter overview with brief description
Parameter Prerequisite Description User interface
Terminal voltage 1 – Displays the current terminal voltage
that is applied at the current output.
0.0 to 50.0 V
Pulse output The Pulse option is selected in the
Operating mode parameter.
Displays the pulse frequency currently
output.
Positive floating-point
number
Output frequency In the Operating mode parameter, the
Frequency option is selected.
Displays the value currently measured
for the frequency output.
0 to 1 250 Hz
Switch status In the Operating mode parameter, the
Switch option is selected.
Displays the current switch output
status.
• Open
• Closed
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using the Setup menu→ 74
• Advanced settings using the Advanced setup submenu→ 86
11.6 Performing a totalizer reset
In the Operation submenu the totalizers are reset:
Control Totalizer
To Next Page
Loading...
