Endress+Hauser Proline 200 - Configuring the Measuring Device

Commissioning Proline Prowirl F 200 PROFIBUS PA
74 Endress+Hauser
10.5 Configuring the measuring device
• The Setup menuwith its guided wizards contains all the parameters needed for standard
operation.
• Navigation to the Setup menu
X X X X X X XX X
20.50
0104-1
XXXXXXXXX
XXXXXXXXX
XXXX
Operation
Setup
Diagnostic
Operation
Setup
Main menu
English
Main menu
Medium selection
/ ../Setup
Language
A0014007-EN
 20 Taking the example of the local display
Overview of the wizards in the "Setup" menu

Setup
Device tag
→  75
‣
Medium selection
→  76
‣
System units
→  78
‣
Communication
→  83
‣
Analog inputs
→  81
‣
Display
→  82
‣
Low flow cut off
→  84
‣
Advanced setup
→  86
10.5.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.